SignWarehouse.com Enduracut Betriebsanweisung PDF herunterladen (Seite 4)

• www.signwarehouse.com • SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020

•Toll Free Phone: 1-800-899-5655 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834

Setting the Heater

Push the red SET button on the black heater

control panel twice. Use the arrows to in-

crease or decrease the temperature to 175°F.

Hit SET again. The Enduraink DTx ink works

best when the surface temperature of the

media is between 140 and 170°F.

1.7

Setting the temperature at 165-180° is the best way to achieve optimal media

surface temperature and drying. Depending on saturation, some prints may need

a few minutes to dry before handling or loading in the vinyl cutter for contour-

cutting.

Note: To see the current temperature of the heater, press the Set button and

Down arrow at the same time.

Installing the Ink Cartridges

When the ink lights turn on, press the ink drop

button on the grey keypad.

The carriage will move to the load

position allowing you to install your ink

Remove the ink cartridges from the sealed bags.

Remove the ﬁlm that covers the breather hole at

the back of the ink cartridge by pulling on the

yellow tab. The ﬁlm can sometimes tear, leaving

the clear end over the hole. Be sure to remove

it completely. The plastic breather hole must

be completely uncovered or ink will not ﬂow

through the print head. If you are not certain,

insert a paperclip or similarly sized object into

the opening to ensure that the hole is clear of

ﬁlm or debris.

1.8

1.9

1.10

cartridges. If during normal use, you experience an ink light, hit the ink drop

button. The head will move to the load position allowing you to replace your ink

cartridge.

YES

1 2 3 4 5 6 7 8 9 ... 80 81

Keine Kommentare

SignWarehouse.com Enduracut Betriebsanweisung Seite 4